SD/SDV-Series

Note

SD and SDV variants share identical technical specifications.

Model Overview

Model	Torque (Nm)	Speed (rpm)	Screw size	Weight
SD/SDV35	0.3 – 3.3	15 – 730	M2.5 – M5	2.4 kg
SD/SDV50	0.5 – 5.0	15 – 510	M2.5 – M5	2.4 kg
SD/SDV70	0.8 – 7.0	15 – 350	M3 – M6	2.4 kg
SD/SDV120	2.0 – 12.0	15 – 180	M5 – M8	2.5 kg

Note

The specified screw capacity is indicative and reflects typical screw sizes within the defined torque range of each tool.

Smaller or larger screws may be used depending on the application, material, and process conditions.

For example:

• SD/SDV120 can be used for smaller screws (e.g. M4)

• SD/SDV35 and SD/SDV50 can be used for larger screws (e.g. M6)

Final tool selection should always be based on the required torque and application conditions.

Model-Specific Specifications

Parameter	SD/SDV35	SD/SDV50	SD/SDV70	SD/SDV120
Torque range (Nm)	0.3 – 3.3	0.5 – 5.0	0.8 – 7.0	2.0 – 12.0
Torque accuracy	±10 %	±10 %	±10 %	±10 %
Speed (rpm)	15 – 730	15 – 510	15 – 350	15 – 180
Screw capacity	M2.5 – M5	M2.5 – M5	M3 – M6	M5 – M8

Mechanical

Parameter	Value
Dimensions	52 × 325 × 159 mm
Safety shield diameter	Ø15 mm
Max screw length (safe)	35 mm
Supported screw types	Machine, self-cutting, self-forming
Robot interface	ISO 9409-1 (50-4-M6)

Electrical

Parameter	Value
Power (from SpinBridge)	42–54 V DC @10A
Motor power	70 W (continuous)
Electrical interface	8-pin M12 (signal) 4-pin M12 (power)

Note

All electrical power for the tool is supplied by the SpinBridge. See Electrical Interfaces for system integration.

Environmental

Parameter	Value
Temperature range	0 – 50 °C
IP classification	IP53
ESD safe	Yes

Vacuum Interface (SDV only)

Parameter	Value
Connection type	Push-in
Tube size	6 mm (OD)
Thread	M5
Minimum vacuum level	≥ 60 % (−0.6 bar)
Vacuum type	Continuous

Note

Vacuum must be supplied externally by the integrator.

Note

The system is not fully sealed. Continuous vacuum is required.