Tool orientation and safety system

The SD/SDV-Series tool includes a spring-loaded safety mechanism that monitors the axial force applied during screwdriving.

This safety system limits both the usable tool orientations and the maximum applicable axial force.

Tool Orientation

The tool is designed for:

  • Vertical operation (recommended)

  • Horizontal operation

Operation in upward direction (screwing upwards) is not supported with the standard safety configuration.

Maximum Axial Force

The maximum axial force that can be applied by the tool depends on the orientation.

Orientation

Maximum axial force [N]

Vertical img1

48 ± 3

Horizontal img2

26 ± 3

Safety Function

The axial force is monitored by the integrated safety sensor.

If the applied force exceeds the specified limits:

  • The safety system is triggered

  • The robot will perform a safety stop

Upward Operation (Important)

Warning

Upward screwdriving is not supported with the standard tool configuration.

Due to the spring-loaded safety mechanism, the safety sensor will be activated before sufficient axial force can be applied.

If upward operation is required:

  • The internal springs must be replaced with stiffer springs

  • The safety system will no longer function as intended

Important

Disabling or modifying the safety system removes the built-in safety functionality of the tool.

The integrator is responsible for implementing alternative safety measures in compliance with applicable standards.

Relation to Risk Assessment (ISO/TS 15066)

The SD/SDV-Series tool is designed to support integration in collaborative robot applications.

The axial force generated by the tool is limited by the integrated spring-loaded safety mechanism.

This characteristic can be used as part of the system risk assessment.

Important

The tool does not ensure compliance with ISO/TS 15066 on its own.

Compliance must be verified at system level by the integrator.

Force Limitation

The maximum axial force generated by the tool is:

  • Up to 48 N (vertical orientation)

  • Up to 26 N (horizontal orientation)

These values define the maximum contact force during operation.

Integration Guidance

During risk assessment, the following should be considered:

  • Contact between tool and human body

  • Contact between robot and surroundings

  • Required axial force for screwdriving

The integrator must verify that:

  • Applied forces are within acceptable limits

  • Protective measures are implemented where required

Application Notes

Note

Required axial force depends on screw type and application.

If the axial force is insufficient:

  • The bit may slip

  • The screw will not be driven correctly

For best performance:

  • Use vertical orientation when possible

  • Use appropriate bit type and condition

  • Replace worn bits regularly