Maintenance and Repair
All maintenance and repairs must be performed in compliance with this manual, including safety instructions.
Only authorized system integrators, or Spin Robotics, shall perform repairs. Unauthorized repairs can lead to warranty void.
Warning
Only use original spare parts.
Warning
Alwats turn off the robot and screwdriver power supply before doing maintenance operations on the screwdriver.
The screwdriver requires only external maintenance, no maintenance is required on the inside. If in need of maintenance on the inside of the tool, please contact the vendor where the tool has been purchased. SD35/70 is not waterproof, proper cleaning should be done on the screwdriver with a dry cloth, with no chemicals, on monthly basis.
Screw Fix and Bit:
Bit and fix for the screwdriver must be inspected visually monthly and after 50.000 cycles. If the screw fix is damaged due to misuse, it will be evident enough to be visually detected. In such cases, the screw fix must be replaced to avoid further damage to the tool.
Check inside the screw bit holder to ensure if there is any debris and make sure the magnetic interface is free of metal shavings and dirt, to ensure maximum grip of screws.
Detach Bits if they show visible damage or wear. Inspect on monthly basis.
Calibration
The screwdriver has been calibrated at Spin Robotics to comply with the specifications in the technical sheet. In case of a calibration report is needed, please contact the vendor from which the tool has been purchased.